The MachinistPost Blog

Drill reconditioning, machining technique, shop management — by machinists, for machinists.

All Posts Technique Business Equipment Materials Troubleshooting
89 posts · TECHNIQUE  ·  Page 4 of 4
TECHNIQUE
Drill Bit Point Geometry
How point angle, lip relief, and chisel edge geometry affect drilling performance and tool life.
October 12, 2026
Read Article →
TECHNIQUE
Drill Bit Geometry Field Guide
A practical field reference for identifying, evaluating, and selecting drill geometries on the shop floor.
September 28, 2026
Read Article →
TECHNIQUE
Drill Bit Anatomy Guide
A complete labeled breakdown of every part of a twist drill and what each feature does.
August 31, 2026
Read Article →
TECHNIQUE
Cutting Speed Myths: Faster Is Not Better
Debunking the belief that higher spindle speed always means faster production and better results.
August 24, 2026
Read Article →
TECHNIQUE
Cutting Fluids Guide For Drilling
Everything a machinist needs to know about cutting fluid selection, dilution, and application for drilling.
August 17, 2026
Read Article →
TECHNIQUE
Cutting Fluids For HSS Drill Bits
A focused guide to choosing and applying cutting fluids specifically formulated for HSS drill performance.
August 10, 2026
Read Article →
TECHNIQUE
Cutting Fluids vs Dry Drilling: A Guide
When to use cutting fluid and when dry drilling is actually the better call for your material.
August 3, 2026
Read Article →
TECHNIQUE
Cutting Fluid For HSS Drill Bits
Which cutting fluids work best with HSS drills and how to apply them for maximum tool life.
July 27, 2026
Read Article →
TECHNIQUE
Countersinking And Counterboring: The Drill Bit Connection
How your pilot drill geometry and condition directly impact countersink and counterbore quality.
July 20, 2026
Read Article →
TECHNIQUE
Countersinking And Counterboring Best Practices
Best practices for countersinking and counterboring that produce clean, accurate seating surfaces.
July 13, 2026
Read Article →
TECHNIQUE
Countersink Geometry: 82 vs 90 vs 100 Degree
When to use 82-, 90-, and 100-degree countersinks and how angle affects fit and finish.
July 6, 2026
Read Article →
TECHNIQUE
Coolant Concentration And Drill Life Correlation
Data-backed look at how varying coolant mix ratios correlates with measurable changes in drill longevity.
June 8, 2026
Read Article →
TECHNIQUE
Coolant Concentration And Drill Life
How coolant concentration ratios directly affect HSS drill edge life and hole quality.
June 1, 2026
Read Article →
TECHNIQUE
Chip Load Drilling Calculation
How to calculate chip load for drilling and why it matters more than spindle speed alone.
April 13, 2026
Read Article →
TECHNIQUE
Chip Evacuation In Deep Hole Drilling
How chip packing kills tools in deep-hole work and the strategies that keep flutes clear.
April 6, 2026
Read Article →
TECHNIQUE
Bench Grinder Resharpening: What You Need To Know
The pros, limits, and geometry pitfalls of sharpening HSS drills on a bench grinder.
February 16, 2026
Read Article →
TECHNIQUE
5 Common Drill Selection Mistakes
Five costly drill selection errors that machinists make and how to avoid them.
January 5, 2026
Read Article →
← Prev 1234